Asocrete BIS-5/40

Cement-based re-profiling mortar, Chloride free, Largest grain size: 2 mm

Features & Advantages

  • For concrete repair
  • As non-slump re-profiling mortar
  • As levelling compound for swimming pools and pool construction.
  • For breakage depths of 5–40 mm
  • For walls and floors

Typical Application

  • Water tight
  • Capable of water vapour diffusion
  • Frost-proof and resistant to de-icing salt
  • High resistance to carbonation
  • Can be spread and sprayed
  • Coating thicknesses up to 20 mm in one application step

Concrete Substrate Standards

Hardness R28 = 15 Mpa
Humidity = < %5
Temperature = +5°C ile +30°C
Relative humidity = < %85
For information about other substrates, please contact with our technical department.

Surface Preparation

All surfaces to be coated must be free of grease, oil, moisture, and other foreign matter. Surfaces should be dry, with release agents and laitance removed by abrasive blasting or acid etching. Surface salt is removed by high pressure water washing. Cement laitance, loose particles, mould release agents must be removed. Fill surface irregularities with relevant product.

PRIMING
Primer is not neccessary for surfaces cleaned properly.

APPLICATION
It is supplied in two-component kits which contain the proper ratio of ingredients. The entire contents of each container must be mixed together. Pot life of mixture is 40 minutes at +20˚C Higher temperatures will reduce pot life of the coating, lower temperatures will increase Don’t mix by manually. It is applied by spatula, trowel or cartridge gun. The prepared holes are filled with starting from the bottom. The application should be at least 2 mm and maximum 30 mm. The Anchoring should be placed in the EPOXY REPAIR which filled in the holes and width and the material should be owerfloved from the hole.

Cleaning of Tools

N/A

Packaging & Colors

N/A

3,75+ 1,25 Kg Sealed Pails  – Grey Color

Shelf Life

N/A

Precaution

Can be kept for minimum 12 months in the original sealed pails in dry places and at temperatures of +5˚C and +25 ˚C. Once opened, use it as soon as possible

Apply in well-ventilated, no smoking areas, away from naked flames. In closed spaces use ventilators and carbon active masks. Hands and eyes must be protected with gloves and protective glasses. Case of eye contact, rinse eyes with plenty of water for the material. The MSDS (Material Safety Data Sheet) is available on request.

Scroll to Top