Bitum 2K

Two component, polymer modified, bitumen and rubber based, liquid membrane. Its adherence is perfect and it has high moisture resistance. It creates a flexible layer with crack bridging. It is produced in accordence with standards DIN 18195 and TSE 15814

Features & Advantages

  • Simple application,
  • Due to high elasticty properties, it provides crack bridging
  • Both vertical and horizontal application
  • When applied forms seamless membrane without joints
  • Solvent free
  • Eco friendly
  • High freeze – thaw resistance
  • Easy to application both in damp and dry surfaces
  • Easy use in closed areas.

Typical Application

  • Foundation and retaining walls
  • Flower pots waterproofing
  • Vertical and Horizontal surfaces
  • Basement and cellars
  • The underground of buildings
  • Settling Tanks
  • Exposed Areas
  • Balconies and terraces

Concrete Substrate Standards

Hardness R28 = 15 Mpa
Humidity = < %5
Temperature = +5°C ile +30°C
Relative humidity = < %85
For information about other substrates, please contact with our technical department.

Surface Preparation

All surfaces must be free of oil, grease and moisture before the application. Clean the surface using a high pressure washer and remove oil, grease and wax contaminants, cement laitance, loose particles, mould release agents must be removed. Fill surface irregularities with the necessary product. Corners and edges should be chamfered with a 4cm radius.

PRIMING
Primer is prepared by mixing homogenously 1kg of BITUM 2K and 5 Lt water by 400 – 600 rpm mixer for 3-4 min. After preparation of priming portion, apply it homogeneously without ponding with suitable brush.

APPLICATION
Add B component (cement) into A component then mix properly and homogenously for 3 -4 minutes by 400-600 rpm mixer. The pot life of the mixture is 60 min at +23 ˚C. After priming, first layer is applied, It is applied min 2 layer, if application will be with brush, layers are applied by cross. Service temperature should be at +5˚C and +30 ˚C. After second layer, it should be protected from heavy weather conditons for 24 hours. BITUM 2K is applied from the side where water comes. Before the foundation pits are filled, the application should be protected by drainage plates and insulation foams.

Cleaning of Tools

Tools are cleaned with water after application.

Packaging & Colors

Tools are cleaned with water after application.

22 Kg + 8 Kg (30 kg Set) – Brownish Black in Plastic Drums

Shelf Life

Can be kept for minimum 12 months in the original plastic pails in dry places and at temperatures of +5˚C and +25 ˚C. Once opened, use as soon as possible. (Pails are protected from freeze.)

Precaution

Can be kept for minimum 12 months in the original plastic pails in dry places and at temperatures of +5˚C and +25 ˚C. Once opened, use as soon as possible. (Pails are protected from freeze.)

Hands and eyes must be protected with gloves and protective glasses. The MSDS (Material Safety Data Sheet) is available on request.

Scroll to Top