Planiseal 88

Planiseal 88

Planiseal 88 is a one-component osmotic mortar, composed of a cement-based compound, selected grade aggregates and special synthetic resins according to a formula developed in MAPEI

Features & Advantages

  • Repairing underground masonries subject to water and moisture seepage in situations with negative pressure up to 1 atmosphere.
  • Waterproofing basins, reservoirs, concrete or masonry tanks containing drinking water.
  • Waterproofing concrete or masonry tanks containing sewage water.

Typical Application

Waterproofing:

  • drinking water reservoirs;
  • interior and exterior cellar walls;
  • damp areas;
  • swimming-pools;
  • lift-rooms; 
  • underground passages; 
  • foundation walls;
  • irrigation channels;

Concrete Substrate Standards

Hardness R28 = 15 Mpa
Humidity = < %5
Temperature = +5°C ile +30°C
Relative humidity = < %85
For information about other substrates, please contact with our technical department.

Surface Preparation

All surfaces to be coated must be free of grease, oil, moisture, and other foreign matter. Surfaces should be dry, with release agents and laitance removed by abrasive blasting or acid etching. Surface salt is removed by high pressure water washing. Cement laitance, loose particles, mould release agents must be removed. Fill surface irregularities with relevant product.

PRIMING
Primer is not neccessary for surfaces cleaned properly.

APPLICATION
It is supplied in two-component kits which contain the proper ratio of ingredients. The entire contents of each container must be mixed together. Pot life of mixture is 40 minutes at +20˚C Higher temperatures will reduce pot life of the coating, lower temperatures will increase Don’t mix by manually. It is applied by spatula, trowel or cartridge gun. The prepared holes are filled with starting from the bottom. The application should be at least 2 mm and maximum 30 mm. The Anchoring should be placed in the EPOXY REPAIR which filled in the holes and width and the material should be owerfloved from the hole.

Cleaning of Tools

N/A

Packaging & Colors

N/A

25 kg bags

Shelf Life

Planiseal 88 may be stored for up to 12 months in its original packaging in a dry place. The product complies with the conditions of Annex XVII to Regulation (EC) N° 1907/2006 (REACH) – All. XVII, item 47

Precaution

Planiseal 88 may be stored for up to 12 months in its original packaging in a dry place. The product complies with the conditions of Annex XVII to Regulation (EC) N° 1907/2006 (REACH) – All. XVII, item 47.

In hot weather, or windy and very sunny days, it is recommended to spray the surface with water to prevent rapid evaporation of mixing water. Before allowing drinking water to come into contact with

Planiseal 88, make sure it has completely set by keeping to the recommended waiting times. Then thoroughly clean all the surfaces and remove all the water used for cleaning before filling. Cleaning Planiseal 88 can be removed from tools with water before it hardens. Once hardened, cleaning becomes difficult and can be carried out only mechanically.

CONSUMPTION
Approx. 1.5 kg/m2 per mm of thickness.